Avaya BCM and VIP-102b config help

[a541106]

I am trying to get our paging system configured to work with our Avaya BCM50. The biggest problem I am having is with SIP configuration which I'm assuming is the only way to do this. I am extremely new to this stuff so be gentle. I was referred to this site by a friend.

Basically I have a VIP-102b with 2 VIP-130 speakers connected that can receive SIP communication for pages.

 

[cook1082]

It looks like you program the valcom program for the phones the trunk device could be an analog COT port to access the valcom. This is from the PDF.

The Valcom VIP-892 Nortel Trunk device provides paging to Nortel IP telephones. Up to 50 IP telephones can be
serviced by one VIP-892. Multiple devices may be programmed to handle larger numbers of telephones. A
maximum of 9 Nortel paging groups are available, using a single digit dial code 1 through 9. Valcom paging
groups can be mapped to the Nortel groups to allow simultaneous paging to other Valcom devices. The Nortel IP
telephone’s XAS address must be set to the IP address of the VIP-892, and graphical mode must be disabled.

 

[a541106]

Ok, do you have a link to the pdf and the page you are referring to?

 

[a541106]

Anyone else have any ideas?