Autoresponder from mobile operator

[BC9CONSONO]

Hi, all!
The situation seems simple: at AXE-10 switch I receive from mobile operator "ti-li-li - the phone is blocked - ti-li-li... " and so on. But MD110 connected through PRI EDSS1 receives only "ti-li-li" w/o message "the phone is blocked". How to transmit the voice message to MD ???

 

[BC9CONSONO]

May be MD110 itself generate "tri-tone"... but why not the message?

 

[whosrdaddy]

are you sure that the speech ath is open at that moment, it could be that the "nu" tone (number unobtainable) is generated on the MD110 side. check the SIG parameter of your route.

http://www.damovo.com

 

[whosrdaddy]

are you sure that the speech path is open at that moment, it could be that the "nu" tone (number unobtainable) is generated on the MD110 side. check the SIG parameter of your route.

http://www.damovo.com

 

[serg75]

That is possible to generate this message ("ti-li-li - the phone is blocked - ti-li-li... &quot by MD110? And how to change NU tone to Busy tone in some route?

 

[rorni]

Hi,

I think the parameters of PRI trunks on MD 110 is set in a such way that speach channel is not open before B-answer from AXE has been sent.
In this case, MD110 will generate the NU tone based on the signalling message received from PSTN.
Have a look on Sig parameters to fix that (parameters about monitoring path)
Regards
rorni

 

[BC9CONSONO]

Hi, many thanks for the answers
SIG parameter was changed from 01111... to 00001... and even D8 to 1, but in vain.

Explain, pls, what does it mean:

"Clearing signal from the line is not received for incoming lines"?

"... for outgoing lines"

"Answer signal from the line is not received for incoming lines"?

Thanks,
//BC9CONSONO

 

[BC9CONSONO]

The problem was solved by means of AXE-10: there was set "Unconditional through connect at ACM".

 

[BC9CONSONO]

And some correction made.