Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations John Tel on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Auto Ringdown Circuits

Status
Not open for further replies.

giantman

IS-IT--Management
Mar 17, 2004
48
US
I have been asked if a T1 terminating into an Option 61c or 81c can emulate auto ringdown circuits ? Each channel would be setup as a ringdown circuit.

Any assistance would be greatly appreciated.

Thank you.

GIANT MAN
 
Not sure if this is what you want but you can make each channel Auto Terminate to the ext you want. That way as soon as that channel sees a signal from the CO it will ing that phone.
 
thats a wiered way to configure a t1 ...why do u need it setup this way?
 
As long as your LEC will place it on the T1, you can make it a RINGDOWN. Most of the time the A-B Bits will be the same as a TIE trunk or DID, just make the RDB auto terminate and then in LD 14 the ATDN will be the EXT you want it to go to.

OLD ROLMEN WORKING ON NORTELS
 
ARD lines are usually private wires used in trading floors. These normally go via copper pair or CAS dc5 signalling.

The two basic principles of Windows system administration:
For minor problems, reboot
For major problems, reinstall
 
Printing trunk usage reports. Traffic program is running on the PBX. System is measuring networks, trunks, console, messaging, call park and broadcasting routes.

Unless I am missing something very obvious, I need to print out trunk group usage on my system. Can someone point me in the right direction ?

Thank you.
 
check the book for load 2. you may be looking for pvl's on those trunks. gives a user a private line in our out. if the t1 is ordered to have 23 different number, and use it one for one. that would be the same as 23 members in a did group. except for full time acd that is to much money, ratio should run for 4 to 20 stations per trunk depending on the bussiness type. here at the hospital it's closer to 50 stations per trunk wothout to many busy signals

john poole
bellsouth business
columbia,sc
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top