auto qos voip cisco-phone

[kcbell]

I am working on a 3750 switch and tried to add the following to the interface Fa1/0/44.

auto qos voip cisco-phone

then I got the following error message. I am running
C3750 Software (C3750-IPBASEK9-M), Version 12.2(44)SE,

I know this is qos for Cisco phone. How do I remedy this problem? I am not upgrading the IOS to a newer version. I am just adding the QOS to the Interface. Thanks!

AutoQoS Error while generating commands on Fa1/0/44.
policy map AutoQoS-Police-CiscoPhone not configured
AutoQoS Error: ciscophone input service policy was not properly applied
Warning: if upgrading from a previous release, and there is already auto qos voip cisco-phone configured on other interfaces, you may need to first delete those auto qos configurations and re-apply them on those interfaces.
policy map AutoQoS-Police-CiscoPhone not configured

 

[VinceWhirlwind]

Shouldn't it be:
auto qos voip trust cisco-phone?

 

[kcbell]

VinceWhirlwind:

" auto qos voip trust " is at the uplink ports.
" auto qos voip cisco-phone " is at each access port.

Following is what I am trying to do: I pulled a switch from a stack and I am trying to duplicate the configuration from a (2) switches stack to two individual switch. After I pulled them apart, I tried to copy and paste the configure from the master to the second switch. Then I got the error message as described.

After I pulled the two switches apart, I saw the configuration of the access ports are on switch 2. My question is how do I copy the configuration from switch 2 to switch 1?

Thanks!

 

[VinceWhirlwind]

do a show int f1/0/44

 

[kcbell]

It is months late...but this is the show interface

interface FastEthernet1/0/1
switchport access vlan 100
switchport mode access
switchport voice vlan 200
switchport port-security maximum 3
switchport port-security
switchport port-security aging time 2
switchport port-security violation restrict
switchport port-security aging type inactivity
srr-queue bandwidth share 10 10 60 20
srr-queue bandwidth shape 10 0 0 0
mls qos trust device cisco-phone
mls qos trust cos
auto qos voip cisco-phone
macro description cisco-phone
spanning-tree portfast
spanning-tree bpduguard enable
!

 

[TheDon5]

I had this error when upgrading from a lower image, we had some auto qos configured which the new image didn't like. To fix it I removed all auto qos config from all interfaces, then re-applied it.

If I remember when I removed the auto qos (no auto qos voip..)
from each int one of the "srr-queue bandwidth.." cmds remained, again I had to remove this before re-applying the auto qos.