Audio Codes Behind Cisco 800 Router

[G van Hamburg]

Has anyone tried to connect an Audiocodes MP10X directly to a Cisco 800 series router.

Whith a switch in between it works fine but the router doesn't seem to see the MP10X at all when we leave the switch out.



Plan your work............Work your plan

 

[UnaBomber]

Sure your cabling is ok?

No idea what a Audiocodes MP10X is but, judging by the fact it works when connecting to a switch and not to a layer 3 device, that would be my guess.

UnaBomber
ccnp mcse2k

 

[G van Hamburg]

Cabling is fine. The port goes to active but the device doesn't show in the mac table.

I'm now looking at the default setting in the thing.

10MB half or whatever. it must be like that.



Plan your work............Work your plan

 

[krishnagondi]

HI,

Use Cross cable between Cisco Router & Audio codes, it should help.

Siva

 

[npereira]

You TP10x is a SIP host card right?
I'm pretty sure you have 2 eth ports on that correct? (I use the Mediant2000 and it has 2 ETH ports as Active/standby).
Make sure your connected to the active port.