AUD 572 and AUD 519

[Captain1911]

Hi.
I have CS1000e HA rls.7.5 latest loadware and dep lists.
2-3 times pr. hour i recieve AUD572 and 519 msg.
Have anyone seen the same, and found a solution for it?


AUD572 1 : 0 0F00CF48 0F00CF4E

AUD0572 Q I MPTR MLN This XMI message register has an invalid queue ID or link pointer. q =
queue being audited, i = message register's queue ID, mptr = message
register pointer, mlnk = link to next message register in queue.
Action:
Severity: Minor. Critical to Monitor: No. SNMP trap: Yes


AUD519 1 299 300

AUD0519 i c l A count of the XMI message registers having queue ID "I" do not match the
field length for that queue's data block. i = queue ID, c = Count for message
register, l = Length from the queue data block.
Action:
Severity: Minor. Critical to Monitor: No. SNMP trap: Yes

 

[Firebird Scrambler]

I found this below that refers to V25.40. It might apply to you?.

Option 81C CP4 rls 25.40

NWS805 produced for every Superloop card in the switch when midnights run eg:

*% NWS805 004 -- MEM
*% NWS301 4 0 : -0 -1 -2
*% NWS805 020 -- MEM
*% NWS805 028 -- MEM
*% NWS301 20 0 : -0 -1 -2 -3 -4 -13 -14
*% NWS301 28 0 : -0 -2 -4 -10 -14
*% NWS805 036 -- MEM
*% NWS301 36 0 : -1 -2 -3 -6 -8 -12 -14
*% NWS805 052 -- MEM
*% NWS301 52 0 : -0 -2 -3 -5 -7 -8 -9 -11 -13
*% NWS805 068 -- MEM
*% NWS805 076 -- MEM
*% NWS301 68 0 : -1 -2 -3 -4 -6 -9 -12 -13
*% NWS301 76 0 : -0 -5 -6 -7
*% NWS805 084 -- MEM
*% NWS805 092 -- MEM

All extns working ok but if you disable one of the loops it cannot be re-enabled - get NPR084.
Command IDU <tn> works ok but IDC <card> results in NPR084.
Trace commands work normally.
If AUDIT run you get:
AUD572 1 : 0 00F2603D 00F26043

AUD519 1 299 300

LD 45, TEST results in BSD023s.

A manual INI cleared the problem for a few days but then it returned. A Sysload was required to clear permanently.


All the best

Firebird Scrambler
Meridian 1 / Succession and BCM / Norstar Programmer in the UK

http://www.linkedin.com/in/davidbromley

If it's working, then leave it alone!.

 

[Captain1911]

Hi, thanks a lot for your reply. I will try the sysload later on when we are retrieving a site into a new mgwy.
Regards Captain 1911