ATT PagePac 20 help

[franklin1232]

I just switched from a Norstar ICS to a Cisco Avvid. I bought a Bogen TAM-B and set it up in station mode off an analog ATA Cisco box. I am able to connect a test set to the output from the TAM-B and hear the page but when it's plugged in to the page input on the Pagepac, nothing. The external page on the ICS was 600ohm so what's wrong with the signal from the TAM-B. I don't have the manual for the pagepac so I am not sure the input specs are.

 

[TouchToneTommy]

The Page Pac is expecting a contact closure from black to yellow on the modular input jack during the page interval. If your interface doesn't provide it, just give it a hard short. The input is 600 ohms.