ATA2 on BCM 1

[mcisar]

Does anybody know if you can use the "flash-*" to access feature codes on an ATA2 attached to BCM. Have tried it here but no luck, get a busy tone back the second I hit either * or #.

Before I pull my hair out further, would like to hear if somebody else has it working

Thanks,
>>>>> Mike <<<<<

 

[aragon]

hook flash * 630 to page
etc...
Works normally no issues.
You may wish to edit the capabilities for the ATA2 DN.
Disable handsfree, disable HF answerback, remove from paging zone.
Change device type to on site phone instead of modem.
There is a ATA2 BCM user guide available;

http://adsl-67-117-181-181.dsl.lsan...tions Manager ATA2 User Guide - Version 2.pdf

 

[mcisar]

Thanks Aragon... turns out that I wasn't flashing slow enough. Seems to take a lot longer hookflash than I'm accustomed to before it recognizes.

Cheers,
>>>>> Mike <<<<<

 

[aragon]

Default hook flash value = 600 ms