Hello all, I would just like to know what happens when port failure occurs, how does it happen is there a certain electrical component that fails for example, a blown capacitor, bad resistor, or whatever or is it the port it self that has gone bad? Also does it usually spread once it happens or does it just take out those couple ports and that's it? Thanks!
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
AT&T Merlin classic port failure?
- Thread starter Frankch95
- Start date
MrTelecom1
Vendor
Most Long-time & long-Ago phone techs are not gonna know BOARD LEVEL failures ...
We find the port doesnt work, we dont use it.. Mark it BAD! When failures occurred back when ATT supported
them and I was a business partner, we simply replaced the control unit.
None of the dealer Dealer & ATT techs opened up the units for board level repair. Broke? replace it!
MrTelecom1
Re-Living the AT&T/Lucent/Avaya issues since 1979!
We find the port doesnt work, we dont use it.. Mark it BAD! When failures occurred back when ATT supported
them and I was a business partner, we simply replaced the control unit.
None of the dealer Dealer & ATT techs opened up the units for board level repair. Broke? replace it!
MrTelecom1
Re-Living the AT&T/Lucent/Avaya issues since 1979!
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question
- Locked
- Question
