Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

AT&T Flex on Magix 1

Status
Not open for further replies.

scooter77

Vendor
Jul 23, 2010
14
US
I have a test number from AT&T and have the system programmed, which is working fine, except for incoming calls are getting a busy signal. Outbound works great. Any suggestions???
 
What digits are being sent by AT&T, do you have a destination for them, what is your Unassigned destination?
 
The invalid destination is set set to backup extension, however, I'm not utilizing DIDs. AT&T says they're sending 7 digits
 
Try building an actual route (versus using the invalid extension destination). I had that happen with an ATT Flex. It wouldn't route unless their was an exact route for it to match.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top