assign ip address to a 2950 port?

[techie211]

Hey ppl, is it possible to assign an ip address to a single port on a 2950? If so, how? I go to the interface config mode, but 'ip address' command doesn't work. We have a lab at our school that has 192.168.4.x running which is seperate from our network which is 10.10.20.x. But there is a printer in the 192.168 lab that an administrator needs access to. Any help is appreciated.

-jr

 

[brycec]

You could use VLANs but without a router, you're going to have problems routing the traffic between them.
Remember it's a switch. It can't route traffic. You would need a "router on a stick" which is basically a router hanging from it with VLANs setup so that you can route traffic accordingly.
Do you have a router spare that you could use?