Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

ASA 5510 Syntax for NAT

Status
Not open for further replies.

ndinc

ISP
Jun 29, 2005
111
US
Cisco Adaptive Security Appliance Software Version 8.3(1)
Device Manager Version 6.3(1)
Compiled on Thu 04-Mar-10 16:56 by builders

Is there some new Syntax that I dont know about with the new 8.3.1? I keep getting the ERROR below each time I try and configure NAT. SSH, HTTP, ASDM and routing seems to be working fine. I cannot eneter ACL or NAT

mullervpn(config)# nat (inside) 1 0.0.0.0 0.0.0.0
ERROR: This syntax of nat command has been deprecated.
Please refer to "help nat" command for more details.
mullervpn(config)#

Any thoughts would be helpful.


Thanks for your help
 
there was a big change from 8.2 to 8.3 in certain commands

would be something like the following now:

object network obj-10.10.10.10
nat (inside,outside) static 123.123.123.123

firewalling has changed a bit to.

list the changes

table 3 is the bit you will be looking for
 
That explains it....

Many Thanks!

Thanks for your help
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top