I have an annoyance. On a couple of boxes here, we have installed both Arcserve 2000 and MS Exchange 5.5 (and the Exchange Agent). The backup jobs run fine, and the mail works fine too. But Arcserve Manager crashes mysteriously on these machines, always when we're not looking at them of course. I always just restart it and it's there when I use it, but if I leave it alone for a few hours, I usually have to open the manager back up again.
On machines where Arcserve 2000 is installed but not Exchange, the manager stays running as I would expect.
Any ideas? Or barring a fix, is there a way to start the manager program so that it jumps right to the job status? I prefer to not use the quick access screen.
Thanks in advance!
On machines where Arcserve 2000 is installed but not Exchange, the manager stays running as I would expect.
Any ideas? Or barring a fix, is there a way to start the manager program so that it jumps right to the job status? I prefer to not use the quick access screen.
Thanks in advance!