ARS w Forced account codes 9100

[mitchell70]

I have a customer that is down sizing from a NEAX 2400 to a SV9100. This is a secured correctional facility and they specifically want to have a current feature working as close to the same as it is now.

The set up is there are 5 RSC classes in the 2400, RSC1 = national Dialing, RSC2 = Instate dialing with additional surrounding state area access. RSC3 = Local & 800, RSC4 = In House only, & RSC 15 unrestricted w International. They currently have forced account code access but for select individuals.

I need to mirror this in the 9100 with ARS but after many attempts and no luck with getting it. Account code still was still required when 1@@ was dialed even if it was built in the ars table to strip the 1.

Can anyone help me with the set up.

 

[CoralTech]

ARS isn't the issue, look into your toll restriction classes. IN 21-XX. Pretty sure what you want are permit codes.

 

[mitchell70]

Coral tech,

Thanks for the input but this is a new install and per NTAC ARS will be needed also. This is to strip digits to allow the local simulation access on all numbers even if they are LD.

I am still in the same issue.