Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

ARS digit conversion

Status
Not open for further replies.

Spookytooth

Vendor
Jul 23, 2004
111
US
Hello all, was wondering if anyone's seen this issue before. I have a G700 remotely connected to an 8700. The G700 has a local wink start t with a block of DID. The t is set up to insert the digit 9 and send all the DID's to the ars digit conversion table. One out of 20 calls or so are failing and ending up at the console as DID? I did some tracing on the trunk and have noticed that on a successful call the outpulse looks like this.

9XXXX#

unsuccessful

9XXXX

I'm not getting the # on the bad ones. Has anyone ran into this with G700's

Thanks
 
Hi,
whats the outgoing line selection code in FAC??
Also has 9 been configured as attendant console???
I guess this could be causing the problem???
need to check further.....if anything will let u know
 
on the trunk form i think either page 2 or 3, try putting a 'n' to suppressing # and monitor it for a while....
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top