Hi, Im not sure what to do here.
Installed ArcServe Rel 11 a couple weeks ago. Seemed to go OK except that the SNMP service on W2K server crashes.
Backups working fine. Whenever you try to start SNMP though, it croaks. In addition, the server seems to be hanging every couple of days,
I may have made matters worse by uninstalling/reinstalling the SNMP service just now. When I did SNMP stared fine. However, when I stopped/started the ARCserve engines - SNMP crashes again. Now Im having a hard time getting exchange agents to respond from inside of my primary backup job.
Anyone ever run into anything like this? CA is telling me its not their problem, what a surprise. I have a feeling if I deinstalled ArcServe - the SNMP service would be just fine.
Any comments appreciated.. Cheers.
Steve
Installed ArcServe Rel 11 a couple weeks ago. Seemed to go OK except that the SNMP service on W2K server crashes.
Backups working fine. Whenever you try to start SNMP though, it croaks. In addition, the server seems to be hanging every couple of days,
I may have made matters worse by uninstalling/reinstalling the SNMP service just now. When I did SNMP stared fine. However, when I stopped/started the ARCserve engines - SNMP crashes again. Now Im having a hard time getting exchange agents to respond from inside of my primary backup job.
Anyone ever run into anything like this? CA is telling me its not their problem, what a surprise. I have a feeling if I deinstalled ArcServe - the SNMP service would be just fine.
Any comments appreciated.. Cheers.
Steve