Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations John Tel on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
anyone program an Audio Code MP-112
- Thread starter PBXT3CH
- Start date
we had issues with these as well - we are using version 5 software which can be configured as below... This process will not work with version 4.x
Configure MP-112
From the config web page:
Protocol Management > Endpoint Phone Numbers
Enter number and give each number a different Hunt Group ID
Protocol Management > Hunt Group Settings
For each Hunt Group Channel Select Mode is By DestPhone Number and Registration mode is Per Endpoint
Protocol Management > Routing Tables > IP to Trunk Group Routing
Enter the Destination Phone prefix (DN) and the Hunt Group ID for each endpoint number.
Protocol Management > Protocol Definition > Proxy & Registration
Enable Proxy: Use Proxy
Proxy IP Address : x.x.x.x (LDR NRS)
First Redundant Proxy IP Address : x.x.x.x (LDR NRS PRI)
Second Redundant Proxy IP Address : y.y.y.y (LDR NRS ALT)
Maintenance > Save Config > Burn.
Configure NRS
Make sure you’re connecting to the Primary Server
Configuration > Standby DB view
Routing entries
Lookup endpoints
Show
Add
DN Type – CDP Steering Code
DN Prefix – <DN>
Route Cost – 1
Tools> Database Actions > Cutover and Commit > Submit
Configure CS1000T's
LD 87
NEW
CUST 0
FEAT CDP
TYPE DSC
DSC <DN>
FLEN 4
RLI 11
Basically the endpoints connect to NRS as dynamic SIP endpoints
The above is a basic config which should get them working...
Have fun..!!
Configure MP-112
From the config web page:
Protocol Management > Endpoint Phone Numbers
Enter number and give each number a different Hunt Group ID
Protocol Management > Hunt Group Settings
For each Hunt Group Channel Select Mode is By DestPhone Number and Registration mode is Per Endpoint
Protocol Management > Routing Tables > IP to Trunk Group Routing
Enter the Destination Phone prefix (DN) and the Hunt Group ID for each endpoint number.
Protocol Management > Protocol Definition > Proxy & Registration
Enable Proxy: Use Proxy
Proxy IP Address : x.x.x.x (LDR NRS)
First Redundant Proxy IP Address : x.x.x.x (LDR NRS PRI)
Second Redundant Proxy IP Address : y.y.y.y (LDR NRS ALT)
Maintenance > Save Config > Burn.
Configure NRS
Make sure you’re connecting to the Primary Server
Configuration > Standby DB view
Routing entries
Lookup endpoints
Show
Add
DN Type – CDP Steering Code
DN Prefix – <DN>
Route Cost – 1
Tools> Database Actions > Cutover and Commit > Submit
Configure CS1000T's
LD 87
NEW
CUST 0
FEAT CDP
TYPE DSC
DSC <DN>
FLEN 4
RLI 11
Basically the endpoints connect to NRS as dynamic SIP endpoints
The above is a basic config which should get them working...
Have fun..!!
- Status
Similar threads
