I'm trying to setup some shortcut bar codes on printed labels (using Intermec 4420 and 3600 printers) to used for getting into the Config menus of the 2425 and changing standard settings (such as the DCS controller IP, ect.) on the scanners with out the need of going through all the menus as we do now through the keypad.
If I use the sample config bar codes that are in the Trakker PDF manual I downloaded from Intermec's web site, they work just fine. If I take the same character sequence (they're printed below each of the bar codes in the manual) and create a bar coded label using Loftware (ver. 6 ) and print it out to the 4420 or 3600 label printer the darn thing doesn't work. I made sure the bar codes were a code 39 Full ASCI just as they are in the manual and the characters pop-up in the User name field ( The log-in screen for our Bar Code App), so I know that I put the correct charters in but for some reason the gun doesn't interpret my label as a command function for accessing the Config menu.
I called Intermec tech support and they told me that there's no special control characters or anything in their labels that are not showing in the print below the bar codes in the manual. They told me that the labels I made should work just fine, but for some reason they don't. Does anyone have any ideas what the problem might be?
Thanks in advance for any suggestions !!!!!!
If I use the sample config bar codes that are in the Trakker PDF manual I downloaded from Intermec's web site, they work just fine. If I take the same character sequence (they're printed below each of the bar codes in the manual) and create a bar coded label using Loftware (ver. 6 ) and print it out to the 4420 or 3600 label printer the darn thing doesn't work. I made sure the bar codes were a code 39 Full ASCI just as they are in the manual and the characters pop-up in the User name field ( The log-in screen for our Bar Code App), so I know that I put the correct charters in but for some reason the gun doesn't interpret my label as a command function for accessing the Config menu.
I called Intermec tech support and they told me that there's no special control characters or anything in their labels that are not showing in the print below the bar codes in the manual. They told me that the labels I made should work just fine, but for some reason they don't. Does anyone have any ideas what the problem might be?
Thanks in advance for any suggestions !!!!!!