Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Announcement only disconnect

Status
Not open for further replies.

plough

Technical User
Jul 12, 2005
279
US
I have a box I have set for announcement only.
After the announcement I would like the system to disconnect - without the message "This box does not accept messages, to log in dial...."

Is there a way to configure this?

 
Requires Application Builder.

Use the announcement block in appbuilder, record your message and connect the success branch to END block.

On the CP, in the SDN table, place the DN you were using in it and associate it with the application you just built.

On the PBX, create a phantom TN with that same DN you have in the SDN table...have the phantom tn DCFW to CP Main Messaging DN
 
I have application builder, but was really trying to avoid using it for the ease of changing the recordings. It confuses the client...
 
What about setting the mailbox settings to ALWAYS Block incoming messages and the Block Message Call Handling parameter to Disconnect caller after greeting?
 
Dabble - That is teh current setup.
However, it still presents the messgae ""This box does not accept messages, to log in dial press... to disconnect just hang up...
 
I think you're stuck with those two options

1) Block incoming messages
2) Use AppBuilder

:( I know I've wanted to do the same thing.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top