Would depend on software release. I would look to see what CLID is programed as. All scr keys will default to table 0. Go to ld 21 to PRT type CLID. It is programmed in ld 15 under NET as the gate opener.
1st step is a pri for outgoing calls, then you can alter data with clid entries, if your using t1's or analog trunks you can have the provider add the company main number, if your showing the last 4 digits to outside lines, a single clid entry will fix it, if you need help setting that up post a question about setting up clid and i'll post the steps from my switch
this is my entry 5, you'll need to build it as your entry 0, that will give you 10 digit clid, if you want a different number for certain stations build one like this
ENTRY 4
HNTN 803
ESA_HLCL
ESA_INHN NO
ESA_APDN YES
HLCL 4348232
DIDN NO
HLOC 434
LSC 434
CLASS_FMT DN
this one shows a 10 digit number we use so people can't do a call back... on the set key 0 scr xxxx 4, assigns clid table 4, by default all sets are clid entry 0, some users want entry 0 to be the main listed number as opposed to their did, like the ceo
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.