Analog to digital wont work

[Jigman32]

I have an 81c with succession 3.0 on it. We have been redoing the cabling on the TN side. Going from 66block to wire wrap. I have been using the mov command in LD 25 to move whole analog cards. The digitals I move one at a time and no ACD sets are being moved. It has been working fine until we tried to program the old analog slots as digital slots. The digitals program ok and stat as idle, but do not work. If I prog. it as an analog again it works fine. I did do an INI and still have the same problem. I can't get digital cards to work when they used to be analog. Has anyone experienced this before?

 

[hawks]

Did you out the card before you built the new sets?

 

[Jigman32]

Regreatably no I did not out them. I have tried the cardslt cmd and it doesnt seem to work for me. If I have an analog phone prog. on the card it say i can't because there is something on it. If I del. what's on it it say it can't because it is unequiped. Most likely I am not doing it correctly.

 

[Jigman32]

I came in early today and did a hard reset of the PBX by shutting it of at the breakers. This fixed it. I geauss a zero got stuck and a hard reboot unstuck it.

I tried disableing the shelf then the controller and reseat the controller, but that didn't work.

Thanks for all the help and advice I did learn a few things.

 

[RickyPone]

Ld 25. That's the fix.

 

[Jigman32]

I assume you mean "That's the fix" as in dont use it.

I think I learned my leasson on that.

 

[RickyPone]

You got that right.