Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Analog DID trunks Problem

Status
Not open for further replies.

power23boy

Technical User
Aug 30, 2005
22
BB
Ihave four analog DID trunks install on a new MICS with 7.0 software, I can only receive calls to the operator if I set the DID trunks to prime, and there is a long delay before the phone rings I have configure the target lines to each telephone along with the received digits.Ihave tested the received digits by connecting my test set at the demarcation point,the correct phone rings.Do I need to used a COMBO card?.
 
If you can go off hook at the dmark and dial the REC DIGITS and hit the Target line then the system is working. Do you know the numbers that Telco is sending you?
 
First telco assigned to the four analog DID trunks four numbers 419-9990/93 then they made a change to the set up, they withdrew the numbers and program the bank of numbers towards thes four trunks, if I call the first #419-9990 I can hear it hit the switch the other three #s two just give ring back tone, next one reorder tone.
I was trying for about three days to ge telco to respond,
no such luck this is becoming very fustrating.I am open to any suggestions.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top