Analog card not responding 1

[Capipo]

HI

I have replaced a digital card for a analog one in a opt 11C system (rls 25.15) but there is no dial tone on any port.

I was changed the card (a known working card) and anything happens. If I change the card for a digital one on this slot, the ports works nornally.

When I try to enable the analog card, the system retriebe NPR326 (No response from card. Retry the command). Only if the card on the slot is a analog one show this message.

I don't known what's the problem. Any idea?.

Thank's a lot.

Capipo.

 

[stroked5o]

Did you build a unit on the card and then enable the card and check for dial tone?

 

[Nortellian]

It sounds like you left all the digital programming in there and just added an analog card. Out all those digital tn's and rebuild as analog 500 type.

 

[Capipo]

stroked5o:

Yes, I build a unit on the analog card, I try two ways to enable the port.

when I try to enable the unit with enlu x x, the stat shows that the unit is enabled (idle) but without dial tone.

If i try to enable the complete card with enlc X, the system after few seconds show me NPR326. Therefore the status shows idle the builded unit and uneq. all others.

I was replace the card for another, but the problem persist.
The problem is present only on this slot and if the card is analog.

Some idea?

Capipo

 

[Capipo]

Nortellian:

Nop, I was erased all digital unit from the card before replace it.

Thanks.

Capipo

 

[unkalary]

When you stat the card in LD 32 how does it appear. Does it have 32 or 16 ports. Alot of times when I would out a digital card in software, the switch would still think it is a digital card slot. The way I fool the system is to program it as a trunk (any type of trunk) and the out it. Dont have to have a trunk card in the slot to do this but it must be vacant (no card). Once I did that, then the system would no longer see it as a digital card. Before doing that, the switch would let me program it as a analog card but as you said NO DIAL TONE. Try that and see what happens

 

[Capipo]

Unkalary:

Thanks for you tip!!! It's the solution!.

The system always show me the slot how a analog card (16 ports). I follow you tip and there is no problem now.

I was try to back to digital card and I was build a digital unit on the slot, then I erased it again but this not fix the problem.

Thanks again for you helpfull tip.

Capipo