Amend and add new trunk group

[Voicedataman]

Hi
I have 4 TIE circuits setup in one trunk group (120 Channels).
I would like to remove 2 tie circuits i.e 60 channels from the group, and add them to a new trunk group to point to a different switch.

i.e. I have trunk group40 x 120 channels, would like to end up with trunk group 40 x 60 channels and new trunk group 41 x 60 channels.

Do I just out individual Tn's from group 40, set up a new group (41) and add Tn's?

for info
loop69 channels 1-30 dch 10
loop78 channels 31-60 dch 12
loop68 channels 61-90 dch 18
loop42 channels 91-120 dch 13

Can't seem to find a NTP with the info init,but it's been a long day!

 

[johnpoole]

as long as you have access to both ends, that is the way i would do it, then build your rlb's to point to that route and it's done.. since you have a d per loop you can skip the dch, tear down and rebuild.. if the switch type is the same it's a short no brainer..

john poole
bellsouth business
columbia,sc

 

[Voicedataman]

thanks Mr Poole ...you're the man!!