Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Alternate Route

Status
Not open for further replies.

Callmaster

Technical User
Mar 6, 2002
136
DE
Hi,

i just want to know how i setup the following,

two locations - cisco cucm 9.1

when location a want to reach location b some colleagues are using the whole external number

+49 89 4208 xxxx

i want to remove the +49 89 4208 and replace with 4 so they use the internal wan and not the pstn

where can i setup this in the cucm ?

thanks in advance
kind regards

With best regards
Callmaster
 
Hi Callmaster,

unfortunatly i'm unable to test this, but I think it can be done as following:

- create translation patterns of the numbers including the leading digit for the outside line (0, 9 or something like that).
- I think it's wise to create a separate partition for these translation patterns so there will not be any conflicts with other configuration.
- Now put that partition in the calling search space(s) which are use by the directory numbers. *** Important*** Place the partition above the partition which is used by your route patterns (otherwise a match is found on the route pattern and it will still be routed out over the pstn).

I think this might work.

 
Silverblade, you are exactly right.

Certifications:
A+
Network+
CCENT
CCNA Voice
TVOICE
CAPPS
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top