We're running Aloha 5.2 in a 3 terminal, single location setup. The Pinnacle hardware is getting creaky after 5 years. Already had 1 HDD and a power supply fail. Didn't see anything in the FAQ, so here goes.
A couple questions:
1) Can we use any old POS terminal with Aloha? Is it just a matter of copying the Aloha files (for example in C:\aloha) to move this to a new POS terminal to enable that terminal to take the place of the old one?
2) Is there a way to reprogram a terminal number? Some terminal locations are more critical than others. For example, can I make Terminal 2 the new Terminal 1 (assuming Terminal 1 is not on the network)?
A couple questions:
1) Can we use any old POS terminal with Aloha? Is it just a matter of copying the Aloha files (for example in C:\aloha) to move this to a new POS terminal to enable that terminal to take the place of the old one?
2) Is there a way to reprogram a terminal number? Some terminal locations are more critical than others. For example, can I make Terminal 2 the new Terminal 1 (assuming Terminal 1 is not on the network)?