Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

ALMOST RETIRED, T7406E (Me, not phone)

Status
Not open for further replies.

phdr

Vendor
Jul 9, 2006
43
US
I have a client (now out of state) that burns thru T7406E every 2-3 years.
I ordered a replacement, direct shipped.
I have the manual....to talk THEM thru set-up

Manual states:
You cannot assign the same port ID to two handsets. If you assign a handset a port ID that is already used by a second handset, the new handset registers with that port ID and that information is discarded from the second handset.

They only have 1 handset connected (dead now)
My Question is can I just ASSIGN PORT ID, then REGISTER HANDSET and be done ??
Will New handset pick up all Station Programming ?? Ext #, ring, button prgm, etc.
 
I would say if you are using the single jack on the back of the base then programming should remain as was.

Try assigning as port 1 is my guess but been awhile.

________________________________________

Add me to LinkedIN

small-logo-sig.png

=----(((((((((()----=
Toronto, CAN
 
Programming is in the KSU port so it will not change. You can assign HS 1 with no issue as long as the old HS is not turned on and registered. Otherwise you will have to de-register the HS. Not a bad idea to do if it will power up to save accidental collision between the two.

Marv ccna

 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top