All 2 keycoded trunks in-use on the DS30 interface

[nooop]

I can only reach the prime set at location B, using VOIP trunks. It logs the above event each time. I have the latest smart updates installed. Any ideas? This used to work perfectly until the smart update was installed. BCM50 2.0.

Thanks

 

[pronei]

You need to program your Priv Received Digits portion of the target lines for your sets.

 

[nooop]

I have them set. This has worked for 6 months perfectly, and it quit. My priv recieved is good. The line never hits the target line, it goes directly to the prime set on the VOIP line instead. I tested different Prime sets on the IP line, and it goes there. So my targets are not answering the calls. Crazy.

 

[pronei]

Have u assigned the targets to the sets in Line Assignment as Ring Only?