gerson2002
Technical User
- Aug 20, 2012
- 2
Hi I just started today my new job so my welcome present was this
for security I painted the public addresses. this was the old topology you see the switch in the middle is gone. the router is our access to the inter we are using fiber my question is.
I going to add another switch to replace the old is a new one both ASA has full configuration the tunnel is working so if I connect the new switch do I need to do some config in the switch to keep the functionality the same?
and what switch should I get they dont want to spend to much money so I need a cisco switch complete enoguh to do the job.
and they want add a Wireless access point to create a network alone to connect to the internet withouth pass the tunnel. All what i need to do is
1- add the new AP
2- create the pool
3 and because the network is connected to the same router the default route 0.0.0.0 0.0.0.0 is enough to get that traffic to the internet
I am right?
please advice baptism of fire .
for security I painted the public addresses. this was the old topology you see the switch in the middle is gone. the router is our access to the inter we are using fiber my question is.
I going to add another switch to replace the old is a new one both ASA has full configuration the tunnel is working so if I connect the new switch do I need to do some config in the switch to keep the functionality the same?
and what switch should I get they dont want to spend to much money so I need a cisco switch complete enoguh to do the job.
and they want add a Wireless access point to create a network alone to connect to the internet withouth pass the tunnel. All what i need to do is
1- add the new AP
2- create the pool
3 and because the network is connected to the same router the default route 0.0.0.0 0.0.0.0 is enough to get that traffic to the internet
I am right?
please advice baptism of fire .
