Adjusting corners

[DigitalChick]

Hi all! I need to create a box with rounded corners. But the standard one has corners that are too rounded. How do I adjust the amount it curves? I looked it up and it said I could do this in the miter submenu, but I couldn't find the miter submenue! Thanks so much.

Julie

 

[dabob]

hi ya back . . .

in quark 6 you select the round corner box tool and then you can modify it by either command M or item > modify to bring up the "modify box" menu . . . left hand column at the bottom . . . corner radius plug a # in there and you adjust the radius of the corner . .. .

bybybybybyby :-D

dabob

 

[tperkins]

Also in your "Measurements Window" the input box to the right of your Height is for your radius for round corners. It is indicated by a quarter radius line and an arrow, you can adjust your corner radiuses with that too.

Tony Perkins