Adding PBX to dialing network

[camaro67]

ok i currently have 3 cs1000 5.0 all linked together via the data network all 3 are 5 digit dialing between them (6 being one location 5 another and 4 is last one) i want to add a fourth PBX. Where would i find the current config. for the 3 pbx's ( assume it's in element manager)so i can get an idea what needs done on the fourth PBX!....Also i was asked to route LD calls from location 6 to location 4s T-1 any help with this would be great!!!

 

[AvayaBlueEngineer]

Are you using H.323, SIP, Point-to-Point?

 

[camaro67]

SIP trunks

 

[AvayaBlueEngineer]

you need to look in NRS for endpoint setup to existing lcations and create new one that has new location IP address. Then you need to create a CDP to the same route that the SIP trunks are a part of:
LD 21
REQ LTM
CUST 0
ROUTE XX

Find the route that has the SIP trunks config'd then:

LD 86

REQ PRT
CUST 0
TYPE RLB
RLI

find the RLI that uses route of SIP found in LD 21

ENTR 0
ROUTE XX

ROUTE XX Should match SIP rout fond in LD 21

then go to ld 87

REQ PRT
CUST 0
TYPE CDP
CDP DSC

DSC 6 (OR 5 OR 4)

DSC 6
FLEN
RLI XX
NPA
NXX

Make a new one using the same info for the "6" CDP.

I would suggest doing a manual backup of the current NRS config first that way if you mess it up, you can restore it quickly and then call your vendor...lol.

 

[camaro67]

i will give this a try! thanks for your help!

 

[camaro67]

is the "NRS" the same thing as a Signaling server?

 

[AvayaBlueEngineer]

The NRS can be found under element manager. It will tahe you to the address of the element manager, eg.

http://(element

manager)/nrs