Adding IOS to a Cisco 3660 router ????

[jonnybegood]

This is a brand new router, straight out of the box. I have a flash image downloaded that I need to install onto it. When I power on the router I get a rommon 1 > prompt. How do I go from here to successfully loading the IOS image. I know I have enough memory in the router to run this image.

 

[matoi]

Hi,

If you are going to load the cisco IOS into the router via Serial Comunication check this. This document explains how to use the xmodem command at the console to download Cisco IOS Software using the ROM monitor (ROMmon).

http://www.cisco.com/warp/public/130/xmodem_generic.html

Hope this helps!

Regards,

Matoi