Adding DSM32 to a BCM 450...Is not recognizing it

[Beauty1982]

Hi folks:

I'm installing a DSM32 MBM in a new BCM 450, I set all the dipswitches in on as it's required, according to the previous configuration realized in the BCM Element Manager, the lights are in green, but in the Telephony resources section says "Enabling" I cannot undestand what's happening, the module is in and greens are green. I wanted to disable this module and the enable it again, but thue buttons are disabled in the BCM Element manager.

What can I do?

Can you give me a hand?

Thanks in advance.

 

[gberger]

Enabling means it's waiting for at least one digital set to be connected then it will show enabled.

 

[Beauty1982]

Hi gberger,
Thanks for your answers, I was confused because I alson instaled a Digital Trunk MBM and this one is enabled, besides I don't have any T1 connected.