Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Adding DSM32 to a BCM 450...Is not recognizing it

Status
Not open for further replies.

Beauty1982

Programmer
May 29, 2008
144
MX
Hi folks:

I'm installing a DSM32 MBM in a new BCM 450, I set all the dipswitches in on as it's required, according to the previous configuration realized in the BCM Element Manager, the lights are in green, but in the Telephony resources section says "Enabling" I cannot undestand what's happening, the module is in and greens are green. I wanted to disable this module and the enable it again, but thue buttons are disabled in the BCM Element manager.

What can I do?

Can you give me a hand?

Thanks in advance.
 

Enabling means it's waiting for at least one digital set to be connected then it will show enabled.

 
Hi gberger,
Thanks for your answers, I was confused because I alson instaled a Digital Trunk MBM and this one is enabled, besides I don't have any T1 connected.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top