Adding Digital Keycodes on Opt 61C

[staabj]

Good morning all,

I will be receiving additional keycodes for digital phones and want to make sure I have the process down correct ahead of time. I know I need to run the KNEW f command in LD 143, but am not sure of the exact steps required. Any assistance will be appreciated.

Thanks in advance,
John

 

[fritzthecat]

Hello staabj,,

first check your existing keycode against the new one,

LD 143

kdif rec ( f0 or f2 ) (depending where your flopy is inserted the files name must be keycode.kcd,

if all is correct then do a knew ( f0 or f1 )

if only ISM parameters are increased, nothing is decrease or pakages are added no sysload is neccessary, this message should com up after applying new keycode ( knew f0 or f1 )

regards

Fritz

 

[staabj]

Thanks fritzthecat,

I'm just increasing ISMs, so I should be ok. I just couldn't remember if I needed to do both proc's or not.

Thanks again!!

John