Adding a UDP number

[kempy4321]

Hello.
Could someone tell me how I can add a new UDP routing number? I need to point one of my PBXs to a new trunk group I just made. I know how to go in and do a cha udp, and enter the udpcode, but I don't know how or where those codes were initially setup.
(G3si v9)

Thanks.

 

[irisngen]

thats the aar entry. which goes to your route pattern

 

[lopes1211]

The UDP codes are essentially made up since they are later deleted in the route pattern. Just follow the current pattern used by your PBX. If you have udp's 111, 112, 113 for example, do a "change aar 111" and see what codes are defined and pick the next number (maybe 114 in this case). Add an aar entry for 114 pointing to a new route pattern you have created which points to the new pbx. Then change the UDP table to steer whatever extentions you want to UDP 114 -> route pattern X -> trunk group Y -> PBX Z.


-CL

 

[kempy4321]

There they are, I see them in the AAR. Thank you so much!