I can find plenty of documentation on installing a new G650 PN. Can't find any on adding a G650 to an existing PN. My question is, since I have to move the existing TDM bus terminator, do I have to power off the entire PN first or can I move the terminator "hot" and connect my new TDM bus cable?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations SkipVought on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Adding a G650 to stack
- Thread starter murph51
- Start date
I have done it hot, but why risk it? If you can shut it down do so as the potential for a pin becoming bent the shorting... well, best to just power down. By the way that means pulling the power cords from the back not just pulling the power supplies out.
**The question may not be the technology, but the competency of the support people.**
**The question may not be the technology, but the competency of the support people.**
- Thread starter
- #4
Just the cabs involved in the addition. By the way, if you have remote maintenence you will need call in an ignore alarms ticket, or simply disconnect the inads line.
**The question may not be the technology, but the competency of the support people.**
**The question may not be the technology, but the competency of the support people.**
- Status
Similar threads
- Locked
- Question