Add IP Addresses to Opt. 11c

[atgjoe]

I need to add some IP addresses to my customers Option 11C, I beleive I add these in load 143, and then NEW but I am struggling from there. Can someone shed some light. thak you ATG Joe

 

[johnpoole]

glance at the book on load 117, that will set the ip address's for the ethernet ports and any ip remote equiptment, by the way, that load responds to a ? very well..

john poole
bellsouth business
columbia,sc

 

[atgjoe]

John, Thank you for your help I am going to restate my question differently because I think I asked incorrectly my orginal question. I am adding more I2004 phones and I bought 25 more IP licenses from Nortel. I have 3 key codes to enter? Would this be load 117? I found the information in my book regarding this load.
Thank you again
ATG Joe

 

[Firebird Scrambler]

You will need to be in LD 143 & also use TTY 0. Key in "upgrade" to get to the menu.

key "2. system upgrade"
Then key "3. option 11c feature / parameter upgrade"

Enter only the changes required in the fields given i.e.. your new 25 IP Sets etc followed by the 3 key codes.
You should get the "keycodes successful message.

A system reboot should not normally be required on later software versions unless there are packages to be added / deleted.
Once that's done you can go into LD 22 & key in "SLT" to list out your system parameters to view the extra IP sets.


All the best

Firebird Scrambler
Meridian Programmer in the UK

 

[atgjoe]

Firebirdscrambler, Thank you very much, it worked. You folks are awesome. ATG Joe