Add a line to Nortel m8x24-ds

[dnuf]

I am adding a line to Nortel m8x24-ds. Lines 1 to 5 work but I can't assign line 6 to an extention. It does not seem to exist! Is the line disabled? Menus are limited compared to MICS, I cant find where I might turn line 6 on or off???

 

[exsmogger]

The following is for the 616 DR5, but it should program the same as the 824:

http://www.jandjcommunications.com/Quick_Reference_Guides/norstar_616_dr5_ds.htm

Brian Cox

http://www.jandjcommunications.com

http://groups.to/jandj/

(updated 3-13-09)

http://phonewire.blogspot.com/

(updated 3-13-09)

 

[dnuf]

the quick ref guide does not seem to be there

 

[exsmogger]

It works for me, but try this:

http://www.jandjcommunications.com/.../norstar/Norstar_616_w_DR5_DS_Programming.pdf

Brian Cox

http://www.jandjcommunications.com

http://groups.to/jandj/

(updated 3-13-09)

http://phonewire.blogspot.com/

(updated 3-13-09)

 

[dnuf]

Ya that should do the job, thanks much. It was the old PC I was using at the customers location. Worked fine from home office.