AD-64 Message notification to a cell phone 2

[imeldesign]

I see this option listed in my AD-64 VM and was wondering how to set it up to work on my Nec 2000IPS. It can't be as easy as putting in the cell number.

Thanks
Melanie

 

[imeldesign]

Help anyone....?

 

[peporter]

Well it pretty much is that easy, you just place your call back number with or without the 9 access code (depends on the Vmail system your on, the system may input the "9" access code for you or it may not)and enable it. Be sure to set the schedule and how often it dials you for notification and how many attempts it takes until failure. Then check out your ports page, and verify that some of your voice ports are set as dial out ports and you should be good to go for a test.

 

[smoom]

If you have access enabled in your mailbox all you would have to do is log into your mailbox, select setup options, then notification, then setup a notification to your cell phone.

 

[imeldesign]

I took out the 9 and viola it worked...thanks to both of you.