After installing Actinic v4, on my W98SE PC with Access 97 already installed and running well, when I try to run queries I get an "Close Down" error with an Invalid Page Fault at OLEAU32.DLL at 017f:65350786.
I have un-installed Actinic and removed all traces (as far as I can see!) including Registry mentions. The problem is still there.
What has the installation of Actinic done to my installation of Access 97?
Does anyone have any idea about conflicts between these two programs? This is the second time! To cure the problem first time I formatted the hard drive and completely re-installed everything. All was fine until I loaded Actinic again. Same error problem as before, same page etc!
I have un-installed Actinic and removed all traces (as far as I can see!) including Registry mentions. The problem is still there.
What has the installation of Actinic done to my installation of Access 97?
Does anyone have any idea about conflicts between these two programs? This is the second time! To cure the problem first time I formatted the hard drive and completely re-installed everything. All was fine until I loaded Actinic again. Same error problem as before, same page etc!