ACS7 Paging WIring Schematic 2

[dennislongnecker]

I need to hook up the paging system to the ACS 7.0 partner system. I will be using CO5. The paging system we have has an RCA jack in;ut plus another input for the relay. At one time I found some wiring schematics on how which wires are to go where, but can't find it the last two days. Anyone know where that is offhand?
Thanks,
Dennis

 

[PhoneFixer98]

Wire the RCA cord to a Surface mount jack with screw terminals by the Phone system, using the center conductor as the tip and the ground as the ring. Then use a single line mounting cord to connect line port 5 to the jack, (assuming the amp you are using accepts a 600 ohm dry loop input). Or, you may have to use a "WMT-1A" by Bogen.

 

[dennislongnecker]

The CO5 jack in the partner system is one of those phone type plugs (RJ45?). I don't know which wire needs to go where. Are wires 1&2 voice and 3&4 the relay?

 

[ravnz5]

If you do it like phonefixer said it will work.

We all need a little help once in awhile. Tony the Phoneman..

 

[ravnz5]

Don't forget to program line 5 as the paging port.

We all need a little help once in awhile. Tony the Phoneman..

 

[TouchToneTommy]

It's an 8-pin jack.

Pins 4 & 5 are the audio.

Pins 3 & 6 are the relay. (Only when using CO-5)