ACCPAC UI INFO ERROR - FAILED TO CREATE OBJECT 1

[DragonFighter082888]

Hi,
Any idea guys, because when I Get Info from ACCPAC UI info
Here's the error appear, Failed to create object. Make sure the object is entered in the system registry.

I already run the regacc and I also reinstall ACCPAC, but still the same error.

Any help will be appreciated.

Thank You,

 

[jonoi]

I had found error "Run time error ActiveX component can't create object" as I don't sure same problem with you.

Solution for this
- Click Start, right click Computer, choose Properties
- Choose Advanced System Settings
- Click "Settings" under "Performance"
Go to the tab "Data execution prevention"
- The selection on that tab is normally on "Turn on DEP for all programs", leave it as is
- Click on Add at the bottom
- Browse to accpac installation folder, then the Runtime folder
- Confirm that accpac.exe file shows up in the list and has a check mark in front of it
- Click OK to confirm

and run regacc.exe in Accpac\Runtime folder

 

[DragonFighter082888]

when I run regacc.exe in Accpac\Runtime folder
i found system error (The program can't start because w3btrv7.dll is missing from your computer).

 

[DragonFighter082888]

addional info : ACCPAC 5.4A

 

[Jay Converse]

Ignore the w3btrv7.dll error, it's because you don't have Pervasive loaded.

Turn off UAC.

 

[DragonFighter082888]

hi dear,
the same problem

 

[DjangMan]

Make sure that UAC is at it's lowest setting.

Then reboot the computer.

Open a command prompt with administrative privileges. Then type regacc and press enter.

See if those specific steps help.

 

[DragonFighter082888]

thanks to all of u guys, It's running now