I am using a 3rd party Cordless IP Phone tru the IP endpoints licenses. The phone is a DECT but the base is networkable.
I managed to register it as an extension and it works very good, however at the end I have encountered a small problem:
The customer uses access codes to dial external numbers, therefore when you dial 00123234 the system beeps for the access code, then you put the access code followed by the pound key (for ex: 123#) and nothing happens, the system beeps again.
Is there a way how you can program a shortcode that when you dial the number followed by some special digits it interprets them as access code. for example:
number 004412345667#123# means dial number 004412345667 and use access code 123.
I managed to register it as an extension and it works very good, however at the end I have encountered a small problem:
The customer uses access codes to dial external numbers, therefore when you dial 00123234 the system beeps for the access code, then you put the access code followed by the pound key (for ex: 123#) and nothing happens, the system beeps again.
Is there a way how you can program a shortcode that when you dial the number followed by some special digits it interprets them as access code. for example:
number 004412345667#123# means dial number 004412345667 and use access code 123.
