A new CLID question

[hollandho]

Hello all: We are running on a Nortel CS1000 R:3. I have created a new CLID entry, but it is not displaying the number that I want. The number that shows up on my blackberry phone is our Main number. All my other CLID entrys apparently are fine. I have a DID coming into the PBX going through the IDC table to extension 121. 121 is set up as a phantom phone with the CFW set up to my cell as a test. All the numbers to be dialled from this setup will be strictly local numbers - no LD.
Here are the printouts of what I think is pertinant. Any advice or comments would be greatly appreciated.
CLID ENTRY

ENTRY 7
HNTN 613
ESA_HLCL 6137386422
ESA_INHN NO
ESA_APDN NO
HLCL 7386422
DIDN YES
HLOC
LSC
CLASS_FMT DN

Phantom TN Ext 121

DES PH7511
TN 152 0 02 00 PHANTOM
TYPE 500
CDEN 4D
CUST 0
WRLS NO
DN 121 7 MARP
AST NO
IAPG 0
HUNT
TGAR 1
LDN NO
NCOS 0
SGRP 0
RNPG 0
XLST 0
SCI 0
SCPW
CLS CTD DTN FBD XFA WTA THFD FND HTD ONS
LPR XRD CWD SWD MWD RMMD SMWD LPD XHD SLKD CCSD LND TVD
CFTD SFD MRD C6D CNID CLBD AUTU
ICDD CDMD LLCN EHTD MCTD
GPUD DPUD CFXA ARHD OVDD AGTD CLTD LDTD ASCD
MBXD CPFA CPTA DDGA NAMA MIND
MCRD
EXR0 SHL ABDD CFHD DNDY DNO3
CWND USMD USRD BNRD OCBD RTDD RBDD RBHD FAXD CNUD CNAD PGND FTTC
CDMR
PLEV 02
CSDN
AACS NO
MLWU_LANG 0
FTR DCFW 12 96138890561
DATE 25 NOV 2009


IDC table (partial)
DCNO 0
IDGT CDGT
415 8304
418 458
422 121
424 7874
425 447
426 697
427 6679
430 8300

 

[bigindian65]

ENTRY 7
HNTN 613
ESA_HLCL
ESA_INHN NO
ESA_APDN yes
HLCL 738
DIDN YES
HLOC
LSC
CLASS_FMT DN


Mato' Was'aka

 

[Reusser]

probably want:

ENTRY 7
HNTN 613
ESA_HLCL 6137386422
ESA_INHN NO
ESA_APDN NO
HLCL 7386422
DIDN YES
HLOC
LSC
CLASS_FMT DN


however, since the phantom numbers are not originating the call - CLID will most likely not change but just pass from what ever number call originated.

Turn on DCH messaging to verify.