a little help with a config please :)

[jdsanchez473]

i have a cisco 1700 series router that is hooked up to a T1 and the ethernet port goes to a zywall (nat router/content filter). I had to start with a new config (somehow the config got erased and there were no backups). I have it far enough now that i can get threw the T1 and ping any address on the internet, but going threw the ethernet port the farthest i can get is the router, and i can't get threw the T1. here is a little rundown of what i've done so far...

serial0 - 70.167.60.17/30
ethernet0 - 192.168.1.1/24

i did "ip route 192.168.1.0 255.255.255.0 serial0"

i setup a computer on the ethernet and gave it an ip of 192.168.1.17/24 and a default gateway of 192.168.1.1

with this config i can't get threw the router, this is my first go around with cisco routers so bear with me please

How i would really like it configured is to have the serial0 and ethernet0 "bridged" (this is where they behave as one interface right?) and have 70.167.60.17 on the ethernet0, and 70.167.60.17 on the zywall (device attatched to ethernet0) is this do-able?

thanks in advance for any help!!

 

[mahlad29]

Hmm, yeah password recovery is really simple.
I think your right about the documentation deal. Very important.

Let us know
and gl

 

[jdsanchez473]

Its all working fine now, and all documented. Thanks a bunch for the help!!!