Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

9608 vs 9608G line noise 2

Status
Not open for further replies.

cdiris

Programmer
Jun 27, 2012
225
US
I have a ticket open with Avaya right now for loud background noise on newer 9608G phone sets (black label). The older phones with a white label don't seem to have the issue. The ticket has been going on now 2 months or so with more and more wiresharks requested all the time. Basically when not talking the user hears loud hiss in the background that changes in pitch. This is IP Office 10.1, 9608G phones on ATT SIP lines--various new firmware releases have been tried with the latest release being the loudest. I think the noise is there on 9608 white label phones a bit but far far in the background. The usual AGC stuff doesn't do anything.

Anyone noticed this behavior? Perhaps you have to be on ATT SIP to hear it?

We have only just begun deploying these phones with the black label...

Thanks!
 
I have a mix of IP phones.
96xx, 56xx, and 16xx.
I have white and black label 9608G phones.
firmware on 9608 is 6.6401
SE R10.1
I 'm not have any issues with background noise.
 
Thanks. What sort of lines are you using?
 
Do you have the same issue on internal calls?

If not then it is probably not a handset issue


Do things on the cheap & it will cost you dear
 
Internal seems to be ok sort of. The same thing could be going on because any noise like ventilation appears amplified. The issue as best I can tell is that one phone type is amplifying certain frequencies that are there in the call but are not noticeable on the older phone type. When I downgraded firmware it got a little better. So either I have to get rid of the ATT noise (or noise IPO is inserting) or fix the new phones...
 
I have encountered a similar issue before and it turned out that it was our firewall that was causing the issue. We had application control enabled and this was causing poor call quality on some of our handsets. More noticable on our calls over our site to site VPN. Turning off H.232 and SIP logging in the application control resolved the issue
 
Thanks we will have to check those things in the firewall. I did find that with extn and ATT SIP lines set to g711 there is no noise. Wish I could turn off g729 but need for fax renegotiate to t38....
 
I didn't see it in your post, is it on an IP 500 and not server edition? IF 500 I think you have bad VCM resources. I have seen something similar before. you said G711 is fine and sounds like the issue I had.
 
Are you using a (wireless) headset or only a handset?

I had some sort of the same issue with a 9504 and a Jabra headset.

9508 is fine.
 
Thanks, could be bad vcm yes--strange the 9608 is not affected though (just the 9608G) but could be amplifying noise that shouldn't be there from the VCM I suppose. Using handset or speaker...
 
Give it a try to use the latest phone firmware 6.6501 (or similar). It is included in the latest 10.0 and 10.1 service packs or can be downloaded separately.

We had an issue with 9608G only (not 9608) that the first few seconds of an outbound call had been silent.
 
Thanks. I think that is the firmware we started with but it is hard to remember now--I'll have to look through my notes. I'll give that a try if we didn't already!
 
Regarding the VCMs the issue is present at multiple sites with separate hardware (connnected SCN). So could still be VCM but less likely. I reproduced the issue on our test system too. Seems to be isolated to this batch of phones. I haven't had another batch of new phones to test since though.
 
Avaya has now duplicated the issue. Basically the newer black label phones are amplifying background noise frequencies (when present) more than the older while label phones do. So depending on what noise is on the lines etc. this can be very distracting. They haven't said what will be done about it yet but at least after a couple months we are on the same page.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top