9600 to Asterisk - call drops after 2 seconds

[Havokmon]

I now have a functional PRI between an Asterisk system, and an F9600. I can call Dt200s at will, and there are no problems. But anytime I call any SIP phone on the Asterisk, doesn't matter how many times it rings, after being connected for about 2 seconds, the Fujitsu appears to disconnect.

I was going to change some TG timings for fun - but I really have no idea where that is done.

Anyone have any suggestions?
(Bchannel TG)

SEIZURE TIMING RELEASE TIMING RLT HOOKFLASH TIMING
Seize Confirm =0ms Out Call Guard =0ms Send Hookflash =0ms
Wink Monitor =64ms Inc Call Guard =0ms Receive Hookflash=0ms
Wink Send =0ms Distant Tie Rel=0ms
Ring Trip Comp =0ms CO Disconnect =0ms
Stop/Go Monitor=256ms
DTMF TIMING ROTARY TIMING STATION DIALING TIMING
Pre-Dial Delay=0sec Pre-Dial Delay=0ms MAX Delay To First Digit=0sec
DTMF signal on=0ms DP Make Time =0ms MAX Delay Between Digits=0sec
Inter-digit =0ms DP Break Time =0ms
DP Inter-digit=0ms

Thanks

 

[Havokmon]

Looks like the 9600 is releasing the call after the connection is made. I've had the opposite problem transferring out PRI's before.. It wouldn't release the call an allow an outside VM to pick up.

I don't know how to tell the 9600 to always supervise the call..

 

[Havokmon]

Changed from 5ess to national on both the Asterisk and Fujitsu, and it all works fine now.