9.0 upgrade...issue with phone sets

[cknipe]

I have already found a resolution for this but wanted t post a heads up.

I upgraded over the weekend to 9.0 and for the most part everything went fine. When I came into the office to double check everything I found a few sets stuck in a loop of upgrading the flash. is this somewhat common for upgrades?

I did a restore defaults on the sets and it cleared everything up. Just wanted to throw that out there in case anyone else runs into this.

 

[kwbMitel]

I had a similar issue when I upgraded to Rel 8.0. The situation was that the sets had a static VLAN assigned but not prioritization. Don't know if this is the same in your case but...

*******************************************************
Occam's Razor - All things being equal, the simplest solution is the right one.

 

[Mitelmatt]

once you've done an upgrade you need to load all ip devices to get the new firmware. Otherwise you can have issues

 

[Lundah]

How many sets were involved with the upgrade? I ran into issues when I went to 8.0, but I chalked it up to the fact that we did 1800 sets and overloaded either the DHCP or TFTP servers (both are handled externally, not by the 3300 in this case).

 

[MitelInMyBlood]

Lundah are you telling us that you went to a N.0 upgrade with 1800 sets? You are brave, brave indeed. I'm afraid to put an N.0 load on my own lab switch, let alone a production box.

 

[tlpeter]

Why not ?
8.0 UR -> UR5 will not go live in the outside world ?
You need to keep working


ACA - Implement IP Office
ACS - Implement IP Office
ACA - Voice Services Management
______________
Women and cats can do as they please and men and dogs should relax and get used to the idea!

 

[Lundah]

MIMB, I had no choice, needed the increased dimensioning/cluster size. At least I was able to wait until UR3 was (somewhat) stable.