Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

9.0 PRI legacy card and FNE services 2

Status
Not open for further replies.

Rhinorhino

Vendor
Aug 29, 2022
98
US
Does anyone know if there are any restrictions using a PRI legacy card on version 9.0 and FNE services?
 
I swapped the legacy PRI card for a newer PRI card that doesn't require the legacy carrier but only provides 8 channels instead of the legacy cards 23 channel.

All FNE services came up and are working. I then swapped that card with a replacement PRI legacy card and FNE services no longer work.

Maybe there's a configuration on the PRI tab that I need to make. Any suggestions.

I do get a dial tone when I call in using the legacy card but I can't break dial tone.
 
I remember reading something that said you can NOT use Mobility features with a PRI Legacy card.
 
Its not supported with US PRI set to T1 mode.

Stuck in a never ending cycle of file copying.
 
it needs to be T1 if you have a T1 even if you set it to PRI it won't work because it won't work at all but apparently that is the type of line it WILL work with

Joe
FHandw, ACSS, ACIS

 
Westi so a legacy T1 or PRI at 9.0 will not work at all for FNE 00,17,31,32,33?
 
When I set it up with a DID I DO get a disk time but it ignores the DTMF. The line shows a TELEWORKER had fished in.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top